SERVO PACKER 500
Continuously fast instead of intermittently slow
Servo Packer 500
The products are wrapped on the SERVO PACKER with continuous product flow. The machine reaches speeds up to 120 cycles/min, which makes the SERVO PACKER 500 the “new fast continuous-motion hybrid from Kallfass” – a mixture of a universal side-sealing machine and a film packaging line for extremely tight packaging.
The SERVO PACKER 500 uses two rolls of flat film. Film trans-port in the machine is made on both sides and perfectly rectangular film bags are created without any distortion. These are the best conditions for accurate sealing seams with square-shaped products, like praline boxes. This machine runs without a forming shoe, as the bag is sealed on all four sides. Not only all standard films, also stiff and brittle biopolymer films can be processed on this machine, e.g. PLA. Extremely dull or poor quality films with acceptable sealing properties are also no problem for the SERVO PACKER.
Facts, Data, Figures
| Technical Data | |
|---|---|
| product rate depends on product and film: | 120 packs per minute |
| width of cross seal bar: | 21 1/2“ |
| max. clearance in height of sealing frame: | 8“ |
| min. product length: | 3“ |
| min. product width: | 3“ |
| film: | flat film, approx. 30 – 250 gauge |
| outside diameter of film reel: | max. 10“ |
| width of film reel: | max. 25 1/2“ |
| speed of transport conveyor, variable: | 15‘ – 115‘/min. |
| sealing system: | permanently heated seal bar with exchangeable sealing ledge temperature regulation and control by PLC |
| operator interface: | Touchpanel SIEMENS |
| programmable logic controller (PLC): | Motion Control SIMOTION® from SIEMENS® |
| power supply: | 480 v/ 3-phase/60Hz with ground |
| rated capacity: | 6 kVA |
| nominal current (at 400 V): | 8.7 amps |
| working height, adjustable: | 31“ – 36“ |
| position of control cabinet: | left hand side in working direction |
| colour: | KALLFASS Anthracite |
| Options at extra cost |
|---|
| film low control (upper and lower film) |
| perforating device with needle roller, 3 rows of needle |
| transport belts with knife edges |
| wheel/knife –combination (patent no EP 10224360.3) for fully closed sealing seams when processing multilayer, eradiated |
| (electronically cross linked) co-polymer films |
| free rotating wear free counter seal bar for films without PP content (registered design) |
| vacuum transport belt for evenly film flow |
| side-inverted execution of machine |
| print registration control (incl. mounting) vertically adjustable (print mark 100 % black), upper film reel |
| single-layer tear-open perforation by cutting wheel for easy opening,upper film reel |
Machine dimensions (approx. in mm):
(This drawing may show options which are not included in the basic machine version and are available against up-charge only.)
